1. Regularly clean, fill with fresh developer and perform maintenance as recommended by the manufacturer; all nozzles/tubes, brushes and rollers should be cleaned frequently and replaced if necessary (the pressure should be checked regularly). If necessary, wash the rollers with water and fresh developer.

2. Always check and replace the filter according to the manufacturer's recommendations. "Filters are the same" is a wrong concept and should be used for each machine.

Lubricate according to the manufacturer's recommendations.

Maintain the temperature and force of the developer and dryer in the developing machine according to the manufacturer's recommendations; use a thermometer to determine the temperature. The speed of the processor must match the plate and developer used.

Check the daily liquid supplement.

3. Check roller tension: Run plates of different thicknesses and evaluate performance and results.

4. Check the wear or excessive running of the guide roller and gearbox.

5. Check if the coupling of the drive shaft and the roller coupling are in a straight line.

6. Check the linear alignment and tension of the drive chain.

7. Inspect attachments and fasteners in any accessible location.

Maintain proper pressure adjustment of the brush to achieve a better cleaning of the particular plate and provide uniform pressure along the overall length of the brush. Use a spring balance to ensure proper adjustment.

8. Store unexposed plates in a low temperature, dry, invisible environment. The earliest plates produced should be used first. Process the plate under a safe light source recommended by the manufacturer. Chemical preparations should be stored at room temperature.

9. Maintain the temperature and activity of the developer in the developing machine as recommended by the manufacturer. The speed of the developing unit must be corrected according to the plate and developer used.

10. Check the daily supply rate of the liquid medicine.

When you are experiencing technical problems with a plate processor failure, please have the following information ready:

Plates and chemicals used; plate evidence (don't damage);

Development time (actual, not reading on the dial);

Development temperature (actual, not on the dial) - measure all developed temperatures with a thermometer;

The temperature of the glue (actual, not the reading on the dial);

Dryer temperature (actual, not reading on the dial);

If a control strip is used, record its value;

The brand, model and size of the developing machine used;

A printed sheet indicating the problem.

Article source address: http://

A4 LED Light Pad

The copying table is also called the writing table and the light-transmitting table. It is currently the most used in animation and comics and is an essential tool.When using it, you can overlap multiple drawings together, and you can clearly see the patterns on the bottom drawing. Using this function, you can easily copy the bottom drawing on the top paper. Therefore, many beginners of painting I will use a copy table to copy my favorite works.

A4 LED Light Pad,LED Tracing Light Box Drawing Board,LED Light Pad with Stand

Guangdong Jishengke Industrial Co.,Ltd , https://www.dgjskpad.com