Film output needs to pay attention to several matters

Exporting film is a seemingly simple and actually very complicated task. It is recommended that before the output center outputs the film, do the following preparations. Electronic file inspection: first check whether your copy of electronic file can be correctly opened on the storage medium, and some storage media, such as MO, floppy disk, etc., have poor storage reliability, so after the electronic file is copied, Check all files open again, including graphics files.

Secondly, check whether the copy of the electronic file is complete, such as Pagemaker Freehand and other group files and graphic files are separate, there is a link between the two, are indispensable.

Film parameter considerations:

1. First of all, we must know the design of the wound's survival size, and the requirements of the film. Such as: Zhengyang, anti-yang, positive yin, anti-yin, there are required network cable and dot shape. If the layout is imposition, the orientation of the imposition is correct.

2, the font problem: the font used to be equipped with the output center, if you use a more remote font, the output should be the font backup (Truetype or PS) along with the electronic file to the output center, it is recommended not to replace The font can easily change the character spacing or alignment.

Film inspection:

A: Whether the surface of the film is dirty or not, sometimes the liquid and the rumble roller can cause the surface of the film to be stained, which will affect the quality of the printing in the future.

B: Is there any error in the content? This usually includes whether the font is garbled or not. The graphics are color separation, whether there is static electricity line, whether the film has scratches, and so on.

C: Question: The four-color version of the corner line, float line, and the label are all available, and whether the four films are tightly nested. In addition, because of the problem of film drafting and the accuracy of the image-setter, the monochrome version comes out. The previous version cannot be strictly set, so the four-color or spot-color version must be output at the same time, otherwise it may be impossible to set it up.