On the afternoon of 29th local time, China ’s fifth Arctic expedition team set up a short-term ice station in the Arctic Ocean ice floe area at 86 degrees 48 minutes north latitude and 120 degrees 15 minutes east longitude. Ice station operation.

According to reports, the short-term ice station operation was carried out by four groups of personnel: the sea ice physics group conducted ice core drilling, carried out observations of sea ice thickness profile, albedo, and snow characteristics, and the sea ice optical group conducted sea ice optical transmission With the albedo observation of sea ice melting pools (water depressions due to melting of the ice surface), the Sea Ice Ecological Group conducts sea ice and ice water interface sample collection and ice temperature profile measurement, and the Sea Ice Atmospheric Group conducts sea ice atmospheric observation and sounding Balloon release, greenhouse gas flux observation on ice.

After 5 hours of operation, the scientific research team collected a total of 48 ice cores, 30 liters of sub-ice seawater, and put 100 meters and 200 meters of deep seawater temperature and salinity meter a total of 10 times. The sea ice mass balance buoy and the sea ice change were deployed. One ice buoy for each data provided by the study.

The ice floe is about 200 meters long and 60 meters wide, with an area of ​​about 12,000 square meters. Tests show that the average thickness of this floating ice is about 1.1 meters to 1.2 meters, and the thickness of the ice is 0.11 meters. The composition of the floating ice is one year of ice-that is, the thin ice that appears every winter and gradually melts in summer. The temperature is higher and the density is looser. Precision GPS measurements show that the ice floe is drifting southeastward at a speed of 0.2 nautical miles per hour (1 nautical mile is equal to 1.852 kilometers).

During the operation, the scientific research personnel and equipment are transported by the ship's "Yellow River" boat to the designated operation area. Before personnel and supplies are on ice, bear guards and designated personnel first observe the surroundings of the ice station, including detecting the ice surface load strength, ice cracks and snow-covered melting pools, etc., and at the same time set up bear-proof observation points. After confirming that there is no danger, the scientific research personnel went to ice to carry out observations. In order to prevent polar bear attacks, the scientific expedition team carried out careful deployment. In addition to the previous bear prevention training, the bear prevention team members and the crew of the "Snow Dragon" driver's bridge have been performing safe observations. "Yellow River" boats and "Dolphin" helicopters are on standby at all times.

On the 25th local time, the "Snow Dragon" moved north along the west side of the Svalbard archipelago in northern Norway to the edge of sea ice at 81 degrees north latitude. On the 27th, the "Xuelong" sailed north from the longitude of 128 degrees east through the northern islands located on the high latitude route and located in northern Russia. As of August 29, the total voyage of the "Snow Dragon" in the scientific expedition reached 12,636 nautical miles, with a cumulative flight time of 1092 hours. At present, the "Snow Dragon" is sailing north along the 120-degree east longitude route.

The highlighter brush is a makeup brush with bristles in the shape of a flame or a fan. It is used to apply highlights to the forehead, cheekbones, bridge of the nose, brow bone, etc., to make them prominent, full and shiny.

Basic information editing
When using the highlight brush, hit the highlight on the forehead, cheekbones, bridge of the nose, brow bone, etc. to make it prominent, full and shiny. Most of the highlights are white powders, which are usually used together with shadow powders to make the face look three-dimensional and sharp.
How to use
The flame brush or fan-shaped brush is directly dipped in the high-gloss product and applied to the cheekbones, bridge of the nose, forehead, etc. After performing a small area of smearing, the entire makeup look natural and comfortable.
step:
(1) T-shaped face
Use a highlighter brush to dip a small amount of Highlighter Powder and swipe the upper part of the eyebrow slightly. Be careful not to apply the highlighter too high, and then apply the highlighter to the bridge of the nose. You can also apply a little to the nose. width.
(2) The sacrum
Hit the highlights from the top of the cheekbones to the corners of the eyes.
(3) Brow bone
Use the highlight brush to brush the highlights under and above the brow bones and eyebrows to make the brow bone more prominent and the face contour more three-dimensional.
(4) other parts
Gently brush the highlights on the jaw, upper eyelid and corner of the mouth.

Highlighter Powder

Highlighter Powder,Glow Kit,Face Highlighter,Highlighter Contour

HENAN BON INDUSTRIAL(COSMETIC) CO.,LTD , https://www.boncosmetic.com